Re: [cisco-ttl] G.SHDSL internet bağlantısı

From: serhat aslan <serhataslan22_at_....>
Date: Mon, 30 Apr 2007 14:15:41 -0700 (PDT)


 Merhaba,

  172.'li bloktan alinan ip'ler yanlis password temelli oldugunu hatirliyorum. Eger baska bir cihaz ile de bu password ve sifreler test edilmisse. IOS surumlerini yukselterek yada indirerek test etmenizi oneririm. Tum ios surumlerinde ayni durum soz konusuysa, mutlaka TTnet ile gorusup kullanici adi ve sifrenizin yeniden tanimlanmasini isteyin. Cunku konfigurasyonda herhangi bir eksik gozume carpmadi. Bunun haricinde kurulum pratigiyle ilgili olarak, dialer-list, access-list, pool-listleri farkli numarandilirsaniz daha iyi olur, binde bir bile olsa bu tur seylerde sorunlar cikabiliyor.

 kolay gelsin,
Serhat Aslan

Salih Ayhan <salih_ayhan_at_yahoo.com> wrote:                                  Merhabalar,
    

   Turk Telekom üzerinden G.Shdsl bağlantısı yapmaya çalışıyoruz.    Cisco 878 konfigurasyonunu yaptık fakat aşağıda görebileceğiniz gibi router 172' li seriden bir ip alıyor. Telekom' dan gelip Zyxel router bağladılar. Dolayısla İnternet bağlantısı sağlandı. hat,kullanıcı adı, ve şifreden emin olduk. Yanlışı nerede yapıyoruz.?     

   Teşekkürler.     

   yourname#sh run
   Building configuration...     

   Current configuration : 3365 bytes
!

   version 12.4
   no service pad
   service timestamps debug datetime msec    service timestamps log datetime msec
   no service password-encryption
!

   hostname yourname
!

   boot-start-marker
   boot-end-marker
!

   logging buffered 51200 warnings
!

   no aaa new-model
!

   resource policy
!

   ip subnet-zero
   ip cef
!

   ip domain lookup
   crypto pki trustpoint TP-self-signed-473921354     enrollment selfsigned
   subject-name cn=IOS-Self-Signed-Certificate-473921354    revocation-check none
   rsakeypair TP-self-signed-473921354
   crypto pki certificate chain TP-self-signed-473921354     

   controller DSL 0
    mode atm
    line-term cpe
    line-mode 2-wire line-zero
   dsl-mode shdsl symmetric annex B
   line-rate auto     

   interface BRI0
   no ip address
   encapsulation hdlc
   shutdown     

   interface ATM0
   no ip address
   no atm ilmi-keepalive
   pvc 8/35
    encapsulation aal5mux ppp dialer
    dialer pool-member 1     

   interface FastEthernet0
   interface FastEthernet1
   interface FastEthernet2
   interface FastEthernet3     

   interface Vlan1
   description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$    ip address 192.168.1.250 255.255.255.0     ip nat inside
    ip virtual-reassembly
   ip tcp adjust-mss 1452
!

   interface Dialer1
   ip address negotiated
   ip nat outside
   ip virtual-reassembly
   encapsulation ppp
    dialer pool 1
   dialer-group 1
    no cdp enable
    ppp authentication pap callin
    ppp pap sent-username user_at_ttnet password 0 123456 ppp ipcp dns request    ip classless
   ip route 0.0.0.0 0.0.0.0 Dialer1
   ip http server
   ip http authentication local
   ip http secure-server
   ip http timeout-policy idle 5 life 86400 requests 10000    ip nat inside source list 1 interface Dialer1 overload    access-list 1 permit any
   dialer-list 1 protocol ip permit
   no cdp run
    control-plane
    line con 0
    login local
    no modem enable
    line aux 0
    line vty 0 4
    privilege level 15
    login local
    transport input telnet ssh
    scheduler max-task-time 5000
    end     

   yourname#sh int dialer1
   Dialer1 is up, line protocol is up (spoofing)

     Hardware is Unknown
     Internet address is 172.20.52.128/32
     MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec, 
        reliability 255/255, txload 1/255, rxload 1/255
     Encapsulation PPP, loopback not set
     Keepalive set (10 sec)
     DTR is pulsed for 1 seconds on reset
     Interface is bound to Vi2
     Last input never, output never, output hang never
     Last clearing of "show interface" counters 3d17h
     Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
     Queueing strategy: weighted fair
     Output queue: 0/1000/64/0 (size/max total/threshold/drops) 
        Conversations  0/0/16 (active/max active/max total)
        Reserved Conversations 0/0 (allocated/max allocated)
        Available Bandwidth 42 kilobits/sec
     5 minute input rate 0 bits/sec, 0 packets/sec
     5 minute output rate 0 bits/sec, 0 packets/sec
        29899 packets input, 480463 bytes
        31389 packets output, 873115 bytes
    
 
 ---------------------------------

 Ahhh...imagining that irresistible "new car" smell?   Check outnew cars at Yahoo! Autos.  

 [Non-text portions of this message have been removed]    

     
                       

       
---------------------------------

Ahhh...imagining that irresistible "new car" smell?  Check outnew cars at Yahoo! Autos.

[Non-text portions of this message have been removed] Received on Tue May 01 2007 - 16:10:08 CEST

This archive was generated by hypermail 2.2.0 : Tue May 01 2007 - 16:10:09 CEST