Re: [cisco-ttl] Re: input errors

From: ilhan salihoglu <ilhansalih_at_....>
Date: Wed Apr 12 2006 - 18:04:50 EEST


Hüseyin bey fastethernet 0/0 altında 24 tane subinterface var ve dot1q çalışıyor.dot1q nun bir limitasyonu varmıdır.
--- Huseyin <huseyinada@yahoo.com> wrote:

> Slm...
> Öncelikle router in conf u da olursa daha sağlıklı
> olur sanıyorum.
> Bu şekilde hatanın nedeni genellikle donanımsal
> oluyor yanii RJ45
> ile ilgili olabilir ama her iki cihaz ın conf ları
> olursa daha
> düzgün yanıt verilebilir.
> Kolay gelsin.
>
>
> --- In cisco-ttl@yahoogroups.com, ilhan salihoglu
> <ilhansalih@...>
> wrote:
> >
> > İyi günler bir problemim mevcut elimde 3725 cat l3
> > switching yapan cihaz car port fast ethernet ten
> 0/0
> > dan 2950cat switch e bağlanıyor. sh int fast 0/0
> > kontrol ettiğimde input errors sürekli artıyor.sh
> > controllers komutuyla baktığımdada en aşağıdaki
> >
> > rx_soft_overflow_err değeri sürekli artıyor.fikri
> olan
> > varmıdır acaba?sh int fast 0/0 çıktısı aşağıdadır.
> >
> >
> >
> > Cat_3725#sh controllers fastEthernet 0/0
> > Interface FastEthernet0/0
> > Hardware is GT96K FE ADDR: 65DE3C1C, FASTSEND:
> > 606555BC, MCI_INDEX: 0
> > DIST ROUTE ENABLED: 0Route Cache Flag: 213
> > GPIO 2 CONF= 7FFF7FFF GPIO 2 IO= 3D003D CIU arbit
> =
> > 80F002BD
> > PHY add register = 0x20 PHY data register =
> > 0xE214780
> > Port Conf Reg= 0x80 ENABLE HT8K HMOD0
> > Port Conf Ex Reg= 0xCD00
> > TX1:1 RXPRI=DE(00) ~FLCNTL ~FLNKP MFL64KB E
> > Port Com Reg= 0x0
> > Port Status Reg= 0xB 100MB FDPX FCTL EN LNK UP
> > ~PAUSED TX oFF
> > Serial Param Reg= 0x218823 Hash table pointer=
> > 0xF5A5B60
> > Source ADDR L= 0x99A0 Source ADDR H= 0xFF701
> > SDMA conf reg= 0x223C RETX 15 RX BE TX BE FRINT
> BSIZE
> > 4
> > SDMA com reg= 0x1010080 SRT TXL STP TXH EN RX
> > IMASK= 0x90003DCD ICause= 0x0
> > Serial 0 mask 30000F3Serial 0 cause 0
> > IpDiffservP0L= 0x0 IpDiffservP0H= 0x0
> IpDiffservP1L=
> > 0x0 IpDiffservP1H= 0x0
> > IP VLAN TAG PRI= 0xF0CC IP VLAN TAG PRI= 0xF0CC
> > First rxd Q0= 0xF5E5DC0 Curr rxd Q0= 0xF5E5DC0
> > First rxd Q1= 0xF5E6040 Curr rxd Q1= 0xF5E6040
> > First rxd Q2= 0xF5E64A0 Curr rxd Q2= 0xF5E64A0
> > First rxd Q3= 0xF5E6900 Curr rxd Q3= 0xF5E6900
> > First txd Q0= 0xF5E6FD0 First txd Q1= 0xF5E75A0
> > gt96kfe_instance=0x65DE56BC, registers=0xB4084800
> > RxRing entries=64, tx ring entries=128
> > RxR0=0x F5E5BE0, RxR1=0x F5E6040, RxR2=0x
> > F5E64A0, RxR3=0x F5E6900
> > Malloc RxR0=0x F5E5BE0, RxR1=0x F5E6040, RxR2=0x
> > F5E64A0, RxR3=0x F5E6900
> > SDOW RxR0=0x65DE5CAC, RxR1=0x65DE5DE0,
> > RxR2=0x65DE5F14, RxR3=0x65DE6048
> > HEAD RxR0=0xF, RxR1=0x0, RxR2=0x0, RxR3=0x0
> > TAIL RxR0=0x0, RxR1=0x0, RxR2=0x0, RxR30x0
> >
> > tx_limited=0(128)
> > TxR0=0x F5E6D60, TxR1=0x F5E75A0
> > COUNT TxR0=0x0, TxR1=0x0
> > Head TxR0=0xE, TxR1=0x0 Tail TxR0=0xE, TxR1=0x0
> >
> > PHY registers:
> > Register 0x00: 1000 782D 0013 78E2 01E1
> 41E1
> > 0007 0000
> > Register 0x08: 0000 FFFF FFFF FFFF FFFF
> FFFF
> > FFFF FFFF
> > Register 0x10: 0000 5780 0000 0000 041A
> 0000
> > 0000 0000
> > Register 0x18: 0000 0000 01C8 0000 FFFF
> 0000
> > 0400
> > Bytes_recvd 1857965109 Bytes_sent 2576676515
> > Frames_recvd 3280379538 Frames_sent
> > 4129384377
> > total_bytes_RX 1857966731 Total_frames_RX
> 3280379541
> > Bcast_frames_recvd 31327899
> > Mcast_frames_RX 104978079 CRC_err 3
> Ovr_sized_frames 0
> > Fragments 0 Jabber 0 collision 0
> > Late_collision 0 64B frame 3377146682;
> 65_127B_frames
> > 2785978150
> > 128_255B_frames 1373914906 256_511B_frames
> 1344776841
> > 512_1023B_frames 395729925
> > 1023_maxB_frames 2427184707 Rx_error 0
> Dropped_frames
> > 0
> > Mcast_frames_tx 957245011 Bcast_frames_tx 213936
> > Sml_frame_recvd 0
> >
> >
> > Software MAC address
> > filter(hash:length/addr/mask/hits):
> > 0x00: 0 ffff.ffff.ffff 0000.0000.0000
> 0
> > 0x57: 0 000f.f701.99a0 0000.0000.0000
> 0
> > 0xC0: 0 0100.0ccc.cccc 0000.0000.0000
> 0
> >
> > ======= Driver Counters =======
> > Number of Transmitter Hang = 1
> > tx_more_col_err= 0 tx_one_col_err= 0
> > tx_exc_collision_err= 0 tx_late_collision_err= 0
> > tx_underrun_err= 1 tx_error_intr= 1
> > rx_soft_overflow_err= 12969228 rx_overflow_err=
> 0
> >
> >
> >
> >
> > Cat_3725#sh int fastEthernet 0/0
> > FastEthernet0/0 is up, line protocol is up
> > Hardware is Gt96k FE, address is 000f.f701.99a0
> (bia
> > 000f.f701.99a0)
> > MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
> > reliability 255/255, txload 55/255, rxload
> 67/255
> > Encapsulation 802.1Q Virtual LAN, Vlan ID 1.,
> > loopback not set
> > Keepalive set (10 sec)
> > Full-duplex, 100Mb/s, 100BaseTX/FX
> > ARP type: ARPA, ARP Timeout 04:00:00
> > Last input 00:00:00, output 00:00:00, output
> hang
> > never
> > Last clearing of "show interface" counters
> 01:29:29
> > Input queue: 3/75/0/0 (size/max/drops/flushes);
> > Total output drops: 2
> > Queueing strategy: fifo
> > Output queue: 0/40 (size/max)
> > 5 minute input rate 26590000 bits/sec, 9001
> > packets/sec
> > 5 minute output rate 21960000 bits/sec, 8740
> > packets/sec
> > 55047477 packets input, 412202146 bytes
> > Received 42054 broadcasts, 0 runts, 0 giants,
> 0
> > throttles
> > 85268 input errors, 0 CRC, 0 frame, 0
> overrun, 0
> > ignored
> > 0 watchdog
> > 0 input packets with dribble condition
> detected
> > 53069156 packets output, 1401224063 bytes, 0
> > underruns
> > 0 output errors, 0 collisions, 0 interface
> resets
> > 0 babbles, 0 late collision, 0 deferred
> > 0 lost carrier, 0 no carrier
> > 0 output buffer failures, 0 output buffers
> > swapped out
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam? Yahoo! Mail has the best spam
> protection around
> > http://mail.yahoo.com
> >
>
>
>
>
>
>
>
>



Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com
--
Cisco Teknik Tartisma Listesi (Cisco-ttl)

Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk 
kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya da 
bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu tutulamazlar. 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/cisco-ttl/

<*> To unsubscribe from this group, send an email to:
    cisco-ttl-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 
Received on Wed Apr 12 18:30:31 2006

This archive was generated by hypermail 2.1.8 : Wed Apr 12 2006 - 18:30:31 EEST