Re: YNT: [cisco-ttl] 1760 router ADSL konfigürasyonu

From: esat yasar caglayan (eycaglayan2003_at_yahoo.com)
Date: Thu Feb 24 2005 - 11:06:29 EET


oradaki pvc 8/35 onu eksik yazm#305;#351;#305;m kusura bakmay#305;n
 
eski tip devrede bulu#351;turdum encapsulation tipini aal5mux seçerek
 
 
fakat yeni tip devrelerde yeni tip devrelerde henüz bulu#351;turamad#305;m konfigürasyonu tekrar gönderiyorum
 
!
interface ATM0/0
 no ip address
 no ip mroute-cache
 load-interval 60
 no atm ilmi-keepalive
 dsl operating-mode auto
 pvc 8/35
  encapsulation aal5snap
  protocol ppp dialer
  dialer pool-member 1
 !
!
interface FastEthernet0/0
 ip address 192.168.2.146 255.255.255.0
 speed auto
!
interface Dialer0
 ip address negotiated
 ip nat outside
 encapsulation ppp
 load-interval 60
 dialer pool 1
 no cdp enable
ppp pap sent-username (username_at_ttnet) password (password)
 
 
sh int dialer 0
Dialer0 is up, line protocol is up (spoofing)
  Hardware is Unknown
  Internet address will be negotiated using IPCP
  MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, loopback not set
  Keepalive set (10 sec)
  DTR is pulsed for 1 seconds on reset
  Interface is bound to Vi2
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 19:24:20
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/0 (size/max total/threshold/drops)
     Conversations 0/0/16 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 42 kilobits/sec
  1 minute input rate 0 bits/sec, 0 packets/sec
  1 minute output rate 0 bits/sec, 0 packets/sec
     917 packets input, 57024 bytes
     7 packets output, 149 bytes
Bound to:
Virtual-Access2 is up, line protocol is down
  Hardware is Virtual Access interface
  MTU 1500 bytes, BW 256 Kbit, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, LCP REQsent
  PPPoATM vaccess, cloned from Dialer0
  Vaccess status 0x44
  Bound to ATM0/0 VCD: 14, VPI: 8, VCI: 35, loopback not set
  Keepalive set (10 sec)
  Interface is bound to Di0 (Encapsulation PPP)
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 01:38:26
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     1046 packets output, 12552 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
 
ilginize te#351;ekkürler
 
 
 

Borusan Oto Istinye Help Desk <helpdesk.istinye_at_borusanoto.com> wrote:

PVC 8/35 olması lazım birde IOS'unun ADSL Kartı destekliyor olması önemli.

________________________________

Kimden: Uragan [mailto:uraganemre_at_superonline.com]
Gönderilmiş: Per 24.02.2005 09:22
Kime: cisco-ttl_at_yahoogroups.com
Konu: Re: [cisco-ttl] 1760 router ADSL konfigürasyonu

selam sankı PVC eksik gibi ????

----- Original Message -----
From: "esat yasar caglayan"
To:
Sent: Wednesday, February 23, 2005 10:09 PM
Subject: [cisco-ttl] 1760 router ADSL konfigürasyonu

iyi çalışmalar 1760 Router üzerinde 1 WIC ADSL interface card ile internete
çıkartmaya çalışıyorum ama bir türlü devreyi up olarak göremedim bana bu
konuda yardımcı olabilir misiniz ?

konfigürasyon aşağıdadır

interface atm 0/0
no ip address
no ip directed broadcast
no ip mroute-cache
pvc /35
encapsulation aal5snap
protocol ppp dialer
dial pool-member 1
!
interface dialer 0
no ip dirtected-broadcast
encapsulation ppp
dialer pool 1
ppp pap sent-username (username_at_ttnet) password (password)

sh int atm 0/0 dediğim zaman serial is up line protocol is up gözüküyor

sh int dialer 0 dediğimde de
virtual template kısmında serial is up line protocol down diyor

yardımlarınız için teşekkürler

---------------------------------
Do you Yahoo!?
Yahoo! Mail - Easier than ever with enhanced search. Learn more.

[Non-text portions of this message have been removed]

Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.

Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir
e-posta gönderebilirsiniz.
Yahoo! Groups Links

Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.

Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
Yahoo! Groups Links

[Non-text portions of this message have been removed]

Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.

Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
Yahoo! Groups Links

                
---------------------------------
Do you Yahoo!?
 Yahoo! Mail - Easier than ever with enhanced search. Learn more.

[Non-text portions of this message have been removed]

Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.

Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/cisco-ttl/

<*> To unsubscribe from this group, send an email to:
    cisco-ttl-unsubscribe_at_yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



This archive was generated by hypermail 2.1.3 : Thu Feb 24 2005 - 21:17:25 EET