[cisco-ttl] PRI config problemi

From: İsmail (ismailcan_net_at_yahoo.com)
Date: Wed Jul 28 2004 - 15:15:12 GMT

  • Next message: Yalçın Atik: "[cisco-ttl] Router a bağlanma"

    I need your helps.
    I try to configure PRI origination scenario.
    I have IVR prompt and customers. Our customers will call four numbers like 2345678. Then I must
    meet them like "Welcome, Pls enter PIN number" via IVR. Then I will authenticate and account
     them using radius server. It is prepaid scenario.
    IVR is on radius server also. Customer may call anywhere (mobile, USA, Germany.......)
    I have configured serial interface and other parts. I need help only with dial-peer, IVR and radius
    part configuration. How can I authenticate customers via Radius. Is there any lack in my config.
    Can you help me?
    isdn switch-type primary-net5
    voice rtp send-recv
    controller E1 0
     pri-group timeslots 1-31
    radius-server host x.x.x.x auth-port 1812 acct-port 1813
    radius-server key 7 0205003337889999
    radius-server vsa send accounting
    radius-server vsa send authentication
    interface Serial0:15
     no ip address
     isdn switch-type primary-net5
     isdn incoming-voice modem
     isdn T309-enable
     isdn send-alerting
     isdn negotiate-bchan resend-setup
     isdn bchan-number-order ascending
     isdn sending-complete
     no cdp enable
    interface FastEthernet0
     ip address d.d.d.d
     duplex auto
     speed auto
     h323-gateway voip interface
     h323-gateway voip id dert ipaddr c.c.c.c 1718
     h323-gateway voip h323-id as5350
    voice-port 0:D
     input gain 6
     echo-cancel coverage 16
     cptone TR
     timeouts interdigit 2
     bearer-cap Speech
    dial-peer voice 312 voip

    Do you Yahoo!?
    New and Improved Yahoo! Mail - Send 10MB messages!

    This archive was generated by hypermail 2.1.5 : Wed Jul 28 2004 - 19:15:43 GMT