Re: [cisco-ttl] atm-to-tunnel switch

From: Devrim Yener Kucuk ([email protected])
Date: Mon Jan 06 2003 - 10:19:02 GMT

  • Next message: Burak Ergun (bergun): "RE: [cisco-ttl] atm-to-tunnel switch"

    Selam Akgun

    Herhalde mumkun degil
    see below...

    > we can switch a pvc , from atm interface to a frame-relay interface
    > like the following:
    > connect test Serial1/0 103 ATM1/0 1/101 service-interworking
    >
    > is the following possible?
    > a vc in atm interface, will be swithced to a vc in a tunnel in a
    > ethernet interface
    > is this possible?

    There is no posibility to enter the target interface as a tunnel
    in the connect command.

    So unless somebody is working on this I do not think this is
    gone be supported soon

    akgun ozsoy wrote:

    > selamlar,atm icerisindeki bir vc'yi frame-relay interface icerindeki
    > pvc'ye switch etmek mumkun.connect test Serial1/0 103 ATM1/0 1/101
    > service-interworkingpeki atm icerindeki vc'yi ethernet uzerinde
    > tanimli tunnel icerindeki bir pvc'ye switch etmek mumkun mu?aradim
    > bulamadim?yapmak istedigim su sekilde:router <--atm --> router
    > <--ethernet (tunnel) --> router <--frame-relay -->
    > routertesekkurler.Akgun
    >
    >
    > Bu listden çıkmak için [email protected] adresine
    > bir e-posta göndermeniz yeterlidir.
    >
    >
    >
    > Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.



    This archive was generated by hypermail 2.1.5 : Mon Jan 06 2003 - 14:20:11 GMT