RE: [cisco-ttl] bridge mode

From: Salim Şişman <whomcwho_at_....>
Date: Thu, 25 Sep 2008 00:41:08 +0300

 

Merhabalar,  

Merkez için şu konfigürasyonu kullanabilirsiniz, Uç(Şube) noktada BVI falan yaratmanıza gerek yok sadece ATM subinterface'i altına atm route-bridged ip parametresini girmeyi unutmayın bu kısım onemli.  

Merkez :  

bridge irbbridge 1 protocol ieeebridge 1 route ip!interface Serial1/1:3.1bridge-group 1frame-relay map bridge 43 broadcast!interface BVI1 ip address 192.168.20.37 255.255.255.252    

Sube :  

interface ATM0               mtu 1500          no ip address               no atm ilmi-keepalive                       dsl operating-mode auto                         cdp enable           ! interface ATM0.1 point-to-point                                ip address 192.168.20.38 255.255.255.252                                        no snmp trap link-status                          atm route-bridged ip            pvc 0/35           protocol ip 192.168.20.37 broadcast                                     encapsulation aal5snap                        !

ip classless
!

ip route 0.0.0.0 0.0.0.0 192.168.20.37
no ip http server        

Salim SismanNetwork / Data & Voice Specialist    

> To: cisco-ttl_at_yahoogroups.com> From: ovatay_at_hotmail.com> Date: Wed, 24 Sep 2008 11:22:33 +0300> Subject: [cisco-ttl] bridge mode> > > Aþaðýdaki þekilde bridge mode da hat çalýþmýyor . sebebi ne olabilir . TT bridge mode çalýþmasý gerek diyor. Bu hat mpls backbone nundan geçiyormuþ TT de..> > Þube;> > interface ATM0/0.1 point-to-point bandwidth 512
bridge-group 1
pvc 0/35
vbr-nrt 512 512
encapsulation aal5snap
!
!

interface FastEthernet0/0
 ip address 10.xx.xxx.1 255.255.255.0
 speed auto
!
!

interface BVI1
ip address 192.168.20.38 255.255.255.252
!

ip classless  

ip route 0.0.0.0 0.0.0.0 192.168.20.37
no ip http server
!

bridge 1 protocol
ieeebridge 1 route ip> > > > > merkez ( kanallý e1 in içinde 512 fr de 512 gshdsl sonlanýyor. )> > interface Serial1/1:3 no ip address encapsulation
frame-relay IETF frame-relay
lmi-type ansi
!

interface Serial1/1:3.1 point-to-point description ** **512gshdsl
bandwidth 512
delay 10
frame-relay interface-dlci 43
http://www.live.com/getstarted.aspx

[Non-text portions of this message have been removed] Received on Fri Sep 26 2008 - 10:51:15 CEST