Merhaba Ergun
Anladigim kadariyla soyle bir topoloji var:
878(remote)---isdn bri--cloud----isdn pri---3600 (central)
878'e bagli olan isdn switch, layer 2 yi surekli "Multiple fram established"
tutmuyor sanirim.
Avrupadaki (ozellikle Almanya ve Fransa) bazi isdn service providerlarda bu
goruluyor.
Soru 1:
asagidaki iki cikti da 878'den mi alindi?
- Layer 2 Status:
TEI = 67, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
- TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
Birinci de TEI= 67,
ikinci de TEI = 0,
birinci cikti BRI ok, ama ikinci cikti PRI gibi geldi ( TEI=0)
?
Soru 2:
878 yerine baska bir routerla (baska bir cisco router ya da third party
router), arama yapilabiliyor mu?
Soru 3:
878 router da kullanilan IOS nedir?
Eger layer 2 hic ayaga kalkmiyorsa,asagidaki bug iyi bir aday olabilir.
CSCsg25693
Externally found severe defect: Resolved (R)
Layer 2 is not coming up in BRI interfaces
Integrated in 12.4(09)T02 12.4(11)T01 12.4(12.02)T
Debug isdn q921 ile switch router arasindaki mesajlari izlemen gerek, ayni
anda debug isdn q931 de enable edip cagri yaptiginda, debuglardan sorun
gorulebilir...
Kolay gelsin.
devrim
- Original Message -----
From: "ERGUN OZSULLU" <ergun.ozsullu_at_bilisimanadolu.com>
To: <cisco-ttl_at_yahoogroups.com>
Sent: Tuesday, April 10, 2007 2:55 PM
Subject: [cisco-ttl] 878 BRI arama sorunu
>
>
>
>
>
> Merhaba,
>
> Lokasyonlarımızandan birine G. bağlantısı kurmak için üzerinde BRI portu
olan 878 router kurduk.
> Amaç G. kesildiğinde BRI arama yaparak merkezimizde bulunan 3662'den bize
ulaşmasını sağlamaktı. G.
> hat oturdu.BRI arama yaptırmak istediğimizde hat yokmuş gibi davranıyor:
>
> xxxxx-xxxx#sh isdn st
> Global ISDN Switchtype = basic-net3
> ISDN BRI0 interface
> dsl 0, interface ISDN Switchtype = basic-net3
> Layer 1 Status:
> ACTIVE
> Layer 2 Status:
> TEI = 67, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
> Layer 3 Status:
> 0 Active Layer 3 Call(s)
> Active dsl 0 CCBs = 0
> The Free Channel Mask: 0x80000003
> Total Allocated ISDN CCBs = 0
>
> Hattı çıakarıp yeniden takınca Layer 2 Status:
> TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
görünüyor fakat kısa bir süre
> sonra tekrar tei_assigned hale dönüyor.Hatta ISDN telefon ile denedik
arama yapabildik.Daha sonra
> merkezden lokasyona BRI araması yapabildik.Fakat ne denersek deneyelim
lokasyondan merkezi aramamız
> mümkün olmadı.Bu sorunu daha önce yaşayan veya bu konu hakkında bilgisi
olan var mı?Şimdiden
> teşekkürler.İyi çalışmalar
>
>
>
> Bu e-posta ve muhtemel eklerinde verilen bilgiler kisiye ozel ve gizlidir.
Anadolu Bilisim Hizmetleri A.S. bu mesajin icerigi ve ekleri ile ilgili
hicbir hukuki sorumluluk kabul etmez. Yetkili alicilardan degilseniz, bu
mesajin herhangi bir sekilde ifsa edilmesi, kullanilmasi, kopyalanmasi,
yayilmasi veya mesajda yer alan hususlarla ilgili olarak herhangi bir islem
yapilmasi kesinlikle yasaktir. Bu durumda hemen mesajin gondericisini
bilgilendiriniz ve mesaji sisteminizden siliniz. Elektronik mesajlar
uzerinde yapilmis herhangi bir degisiklik veya sonuclari uzerinde Anadolu
Bilisim Hizmetleri A.S.'nin sorumlulugu yoktur. Ayrica, e-posta
mesajlarindaki hata ve/veya eksiklikten, virus icermesinden ve bilgisayar
sisteminize verebilecegi herhangi bir zarardan Sirket olarak sorumluluk
kabul etmeyecegimizi de bildiririz.
>
> This e-mail and any information included within any attached document are
private and confidential and intended solely for the addressee. Anadolu
Bilisim Hizmetleri A.S. does not accept any legal responsibility for the
contents of this message and any attached documents. If you are not the
intended addressee, it is forbidden to disclose, use, copy, or forward any
information within the message or engage in any activity regarding the
contents of this message. In such case please notify the sender and delete
the message from your system immediately. Anadolu Bilisim Hizmetleri A.S.
also denounces any legal responsibility for any amendments made on the
electronic message and the outcome of these amendments, as well as any error
and/or defect, virus content and any damage that may be given to your
system.
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> --
> Cisco Teknik Tartisma Listesi (Cisco-ttl)
>
> Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk
> kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya
da
> bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu
tutulamazlar.
> Yahoo! Groups Links
>
>
>
Received on Wed Apr 11 2007 - 12:42:12 CEST