Cisco Teknik Tartisma Listesi Arsivi: Re: [cisco-ttl] qos bandwi

From: Serhat Uslay <serhat.uslay_at_....>
Date: Fri Dec 29 2006 - 22:23:27 CET

bir de QoS-Policy-Trust policy tanimlarini yollarmisin ?

Serhat

emre aksoy <enisaksoy2000@yahoo.com>
Sent by: cisco-ttl@yahoogroups.com
29/12/2006 11:03 PM
Please respond to
cisco-ttl@yahoogroups.com

To
cisco-ttl@yahoogroups.com
cc

Subject
Re: [cisco-ttl] qos bandwith sorunu

map-class frame-relay VOIPovFR-256K

frame-relay cir 256000
frame-relay bc 2560
frame-relay be 0
frame-relay mincir 256000
frame-relay fragment 320
frame-relay ip rtp priority 16384 16383 120

no service-policy output VOICE-POLICY- 256K service-policy output QoS-Policy-Trust

bu nu aktif edince gönderdiğim hataya alıyorum

interface Serial1/5:2.1 point-to-point description ISTOC 0106031561 LL 256
bandwidth 256
ip address 10.255.0.49 255.255.255.252
ip nbar protocol-discovery

 ip summary-address eigrp 100 192.168.0.0 255.255.0.0 5
 ip summary-address eigrp 100 172.16.0.0 255.240.0.0 5
 ip summary-address eigrp 100 10.0.0.0 255.0.0.0 5

frame-relay interface-dlci 150
class VOIPovFR-256K

frame-relay ip rtp header-compression
end

SOURCE#show interfaces serial 1/5:2
Serial1/5:2 is up, line protocol is up
Hardware is Multichannel E1
MTU 1500 bytes, BW 256 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation FRAME-RELAY, crc 16, Data non-inverted Keepalive set (10 sec)
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0 LMI enq recvd 782, LMI stat sent 782, LMI upd sent 0, DCE LMI up LMI DLCI 0 LMI type is ANSI Annex D frame relay DCE FR SVC disabled, LAPF state down
Broadcast queue 0/64, broadcasts sent/dropped 2602/0, interface broadcasts 2471
Last input 00:00:01, output 00:00:01, output hang never Last clearing of "show interface" counters 02:16:30 Input queue: 0/75/0/0 (size/max/drops/ flushes); Total output drops: 0 Queueing strategy: dual fifo
Output queue: high size/max/dropped 0/256/0 Output queue: 0/128 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 37831 packets input, 1364474 bytes, 0 no buffer Received 0 broadcasts, 9 runts, 0 giants, 0 throttles 10 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 1 abort 43451 packets output, 2393492 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 output buffer failures, 0 output buffers swapped out 0 carrier transitions
no alarm present
Timeslot(s) Used:27-30, subrate: 64Kb/s, transmit delay is 0 flags

SOURCE#show interfaces serial 1/5:2.1
Serial1/5:2. 1 is up, line protocol is up Hardware is Multichannel E1
Description: ISTOC 0106031561 LL 256
Internet address is 10.255.0.49/ 30
MTU 1500 bytes, BW 256 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation FRAME-RELAY
Last clearing of "show interface" counters never

Policy Map QoS-Policy-Trust
Class QoS-VoIP-RTP- Trust
------------ --------- - Class Map match-any QoS-VoIP-RTP- Trust (id 11)
------------ --------- --- Match ip dscp ef (46)

Strict Priority
Bandwidth 70 (%)
Class QoS-VoIP-Control- Trust
------------ --------- ----- Class Map match-any QoS-VoIP-Control- Trust
(id 12)

------------ --------- ------ Class Map match-any QoS-VoIP-Control- Trust
(id 12)

------------ --------- ----- Match ip dscp cs3 (24) ------------ --------- -----Match ip dscp af31 (26) Bandwidth 5 (%) Max Threshold 64 (packets) Class class-default
Flow based Fair Queueing
Bandwidth 0 (kbps) Max Threshold 64 (packets) Policy Map QoS-Policy-Trust
Class QoS-VoIP-RTP- Trust
Strict Priority
Bandwidth 70 (%)
Class QoS-VoIP-Control- Trust
Bandwidth 5 (%) Max Threshold 64 (packets) Class class-default
Flow based Fair Queueing
Bandwidth 0 (kbps) Max Threshold 64 (packets

Devrim Yener KUCUK <dkucuk@cisco.com> wrote:

Emre

Konfigurasyonu ya da maili tam olarak goremiyorum.

Ancak gorulen hata mesaji reserved Qos ile ilgili.

Gorulen hata mesaji:
"class QoS-VoIP-RTP-Trust requested bandwidth 70%, available only 53%"

F/R de QoS'un kullanacagi (available bandwidth) minCIR degeri ile tanimlanir...
Eger minCIR tanimli degilse, CIR/2 kullanilir.

Bu class'in kullandigi minCIR degerini yukseltip (test icin) , tekrar dener misin.
(ornegin 256k ise, test icin 512k yapabilirsin...)

Devrim

Original Message ----- From: emre aksoy To: cisco-ttl@yahoogroups.com Sent: Thursday, December 28, 2006 6:01 PM Subject: Re: [cisco-ttl] qos bandwith sorunu

routerda asagidaki komutu verdigimde su hata mesajini aliyorum. I/f Serial1/5:2.1 DLCI 150 class QoS-VoIP-RTP-Trust requested bandwidth 70%, available only 53%

gerekli ciktilar asagidaki gibidir
Devrim Yener KUCUK <dkucuk@cisco.com> wrote: map-class frame-relay VOIPovFR-256K

frame-relay cir 256000
frame-relay bc 2560
frame-relay be 0
frame-relay mincir 256000
frame-relay fragment 320
frame-relay ip rtp priority 16384 16383 120

no service-policy output VOICE-POLICY-256K service-policy output QoS-Policy-Trust

qos değerlerini girdiğimde aşağıdaki hata ile karşılaşıyorum.Gerekli çıktılar aşagıdaki gibidir yardımcı olabilirseniz sevinirim.

I/f Serial1/5:2.1 DLCI 150 class QoS-VoIP-RTP-Trust requested bandwidth 70%, available only 53%

SOURCE#show interfaces serial 1/5:2
Serial1/5:2 is up, line protocol is up
Hardware is Multichannel E1
MTU 1500 bytes, BW 256 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation FRAME-RELAY, crc 16, Data non-inverted Keepalive set (10 sec)
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0 LMI enq recvd 782, LMI stat sent 782, LMI upd sent 0, DCE LMI up LMI DLCI 0 LMI type is ANSI Annex D frame relay DCE FR SVC disabled, LAPF state down
Broadcast queue 0/64, broadcasts sent/dropped 2602/0, interface broadcasts 2471
Last input 00:00:01, output 00:00:01, output hang never Last clearing of "show interface" counters 02:16:30 Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: dual fifo
Output queue: high size/max/dropped 0/256/0 Output queue: 0/128 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 37831 packets input, 1364474 bytes, 0 no buffer Received 0 broadcasts, 9 runts, 0 giants, 0 throttles 10 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 1 abort 43451 packets output, 2393492 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 output buffer failures, 0 output buffers swapped out 0 carrier transitions
no alarm present
Timeslot(s) Used:27-30, subrate: 64Kb/s, transmit delay is 0 flags

SOURCE#show interfaces serial 1/5:2.1
Serial1/5:2.1 is up, line protocol is up Hardware is Multichannel E1
Description: ISTOC 0106031561 LL 256
Internet address is 10.255.0.49/30
MTU 1500 bytes, BW 256 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation FRAME-RELAY
Last clearing of "show interface" counters never

Policy Map QoS-Policy-Trust
Class QoS-VoIP-RTP-Trust
---------------------- Class Map match-any QoS-VoIP-RTP-Trust (id 11)
------------------------ Match ip dscp ef (46)

Strict Priority
Bandwidth 70 (%)
Class QoS-VoIP-Control-Trust

-------------------------- Class Map match-any QoS-VoIP-Control-Trust (id

12)

--------------------------- Class Map match-any QoS-VoIP-Control-Trust (id

12)

-------------------------- Match ip dscp cs3 (24)
--------------------------Match ip dscp af31 (26)

Bandwidth 5 (%) Max Threshold 64 (packets) Class class-default
Flow based Fair Queueing
Bandwidth 0 (kbps) Max Threshold 64 (packets) Policy Map QoS-Policy-Trust
Class QoS-VoIP-RTP-Trust
Strict Priority
Bandwidth 70 (%)
Class QoS-VoIP-Control-Trust
Bandwidth 5 (%) Max Threshold 64 (packets) Class class-default
Flow based Fair Queueing
Bandwidth 0 (kbps) Max Threshold 64 (packets)

[Non-text portions of this message have been removed]

--
Cisco Teknik Tartisma Listesi (Cisco-ttl)

Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk
kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya
da
bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu
tutulamazlar.
Yahoo! Groups Links








----
This email is intended for the named recipient only. It may contain information which is confidential, commercially sensitive, or copyright. If you are not the intended recipient you must not reproduce or distribute any part of the email, disclose its contents, or take any action in reliance. If you have received this email in error, please contact the sender and delete the message. It is your responsibility to scan this email and any attachments for viruses and other defects.
To the extent permitted by law, Zurich and its associates will not be liable for any loss or damage arising in any way from this communication including any file attachments. We may monitor email you send to us, either as a reply to this email or any email you send to us, to confirm our systems are protected and for compliance with company policies. Although we take reasonable precautions to protect the confidentiality of our email systems, we do not warrant the confidentiality or security of email or attachments we receive.

[Non-text portions of this message have been removed]

Received on Wed Jan 3 20:19:33 2007

This archive was generated by hypermail 2.1.8 : Wed Jan 03 2007 - 20:19:33 CET