Merhaba,
Eger loglarda
%CONTROLLER-2-FIRMWARE: Controller E1 0/1, firmware is not running
seklinde bir tanim goruyorsaniz bu bilinen bir bug'dan kaynaklaniyor.
CSCdy01451<http://wwwin-metrics.cisco.com/cgi-bin/ddtsdisp.cgi?id=CSCdy01451>-
%CONTROLLER-2-FIRMWARE: Controller E1 firmware is not
running
Integrated in
012.002(026.005) 12.2(26.04)S 012.002(026) 12.3(09.08)T 012.003(009.008)
Release-Note
A Cisco Router may display the following message:
%CONTROLLER-2-FIRMWARE: Controller E1 X, firmware is not running
%CONTROLLER-2-FIRMWARE: Controller T1 X, firmware is not running
First try to reseat the NM or (V)WIC. If the error message persists
after reseating the card, then the following bugs are applicable,
depending on the specific HW in use:
CSCdy01451<http://wwwin-metrics.cisco.com/cgi-bin/ddtsdisp.cgi?id=CSCdy01451>
VWIC-MFT-G.703 or VWIC-MFT-T1-DI (specific to EADI)
CSCed60369<http://wwwin-metrics.cisco.com/cgi-bin/ddtsdisp.cgi?id=CSCed60369>VWIC-MFT-E1
(non Drop and Insert (V)WICs)
CSCed60365<http://wwwin-metrics.cisco.com/cgi-bin/ddtsdisp.cgi?id=CSCed60365>NM-CE1
CSCed28783<http://wwwin-metrics.cisco.com/cgi-bin/ddtsdisp.cgi?id=CSCed28783>NM-CE1/NM-CT1
in conjunction with an NM-HDA
There is no workaround. If reseating the card does not resolve the problem,
the only recovery is to reload the router.
Ozgur
2006/9/30, Salih ERGULEN <salihergulen@yahoo.com>:
>
> Selam ;
>
> Elimde cisco 2811 serisi router var. Üzerindeki kongigurasyona ek olarak
> yeni bir
> WIC/VIC-E1 kart ekledim sh diag komutuyla bağlı modülleri görüyorum ve
> eklediğim kart slot 1 üzerinde görünmektedir. daha önce sh run çıktısında
> controler 0/1 olarak görünmekteydi fakat şu anda göremiyorum.
>
> card type komutu ile manuel olarak kartı tanıtmak istedim komutu ne config
> nede glabal mode yemiyor.
>
> Konuyla ilgili bilgisi olan veya sorun daha önce yaşamış birinden destek
> bekliyorum.
> Tşk
>
> ROUTER # sh diag
> Slot 0:
> C2811 Motherboard with 2FE and integrated VPN Port adapter, 2 ports
> Port adapter is analyzed
> Port adapter insertion time unknown
> EEPROM contents at hardware discovery:
> PCB Serial Number : FOC1006505Q
> Hardware Revision : 1.0
> Top Assy. Part Number : 800-26920-01
> Board Revision : A0
> Deviation Number : 0
> Fab Version : 03
> RMA Test History : 00
> RMA Number : 0-0-0-0
> RMA History : 00
> Processor type : 87
> Hardware date code : 20060215
> Chassis Serial Number : FCZ1009712B
> Chassis MAC Address : 0016.c85f.e8e8
> MAC Address block size : 24
> CLEI Code : CNMJ7P0BRB
> Product (FRU) Number : CISCO2811
> Part Number : 73-10258-03
> Version Identifier : V02
> EEPROM format version 4
> EEPROM contents (hex):
> 0x00: 04 FF C1 8B 46 4F 43 31 30 30 36 35 30 35 51 40
> 0x10: 03 E7 41 01 00 C0 46 03 20 00 69 28 01 42 41 30
> 0x20: 88 00 00 00 00 02 03 03 00 81 00 00 00 00 04 00
> 0x30: 09 87 83 01 32 18 37 C2 8B 46 43 5A 31 30 30 39
> 0x40: 37 31 32 42 C3 06 00 16 C8 5F E8 E8 43 00 18 C6
> 0x50: 8A 43 4E 4D 4A 37 50 30 42 52 42 CB 8F 43 49 53
> 0x60: 43 4F 32 38 31 31 20 20 20 20 20 20 82 49 28 12
> 0x70: 03 89 56 30 32 20 D9 02 40 C1 FF FF FF FF FF FF
> WIC Slot 0:
> Serial 2T (12in1)
> Hardware revision 1.0 Board revision D0
> Serial number 32190884 Part number 800-03181-01
> FRU Part Number WIC-2T=
> Test history 0x0 RMA number 00-00-00
> Connector type PCI
> EEPROM format version 1
> EEPROM contents (hex):
> 0x20: 01 12 01 00 01 EB 31 A4 50 0C 6D 01 00 00 00 00
> 0x30: 68 00 00 00 00 10 12 00 FF FF FF FF FF FF FF FF
> WIC Slot 1:
> E1 (2 port) Multi-Flex Trunk WAN daughter card
> Hardware revision 1.0 Board revision B0
> Serial number 31518012 Part number 800-04479-03
> FRU Part Number WIC/VIC-E1,DUAL=
> Test history 0x0 RMA number 00-00-00
> Connector type PCI
> EEPROM format version 1
> EEPROM contents (hex):
> 0x20: 01 23 01 00 01 E0 ED 3C 50 11 7F 03 00 00 00 00
> 0x30: 58 00 00 00 02 09 13 00 FF FF FF FF FF FF FF FF
> WIC Slot 2:
> E1 (2 port) Multi-Flex Trunk WAN daughter card
> Hardware revision 1.0 Board revision B0
> Serial number 29238042 Part number 800-04479-03
> FRU Part Number WIC/VIC-E1,DUAL=
> Test history 0x0 RMA number 00-00-00
> Connector type PCI
> EEPROM format version 1
> EEPROM contents (hex):
> 0x20: 01 23 01 00 01 BE 23 1A 50 11 7F 03 00 00 00 00
> 0x30: 58 00 00 00 02 09 13 00 FF FF FF FF FF FF FF FF
> WIC Slot 3:
> Serial 2T (12in1)
> Hardware revision 1.0 Board revision D0
> Serial number 32190883 Part number 800-03181-01
> FRU Part Number WIC-2T=
> Test history 0x0 RMA number 00-00-00
> Connector type PCI
> EEPROM format version 1
> EEPROM contents (hex):
> 0x20: 01 12 01 00 01 EB 31 A3 50 0C 6D 01 00 00 00 00
> 0x30: 68 00 00 00 00 10 12 00 FF FF FF FF FF FF FF FF
>
>
> ---------------------------------
> Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls. Great rates
> starting at 1¢/min.
>
> [Non-text portions of this message have been removed]
>
>
>
[Non-text portions of this message have been removed]
--
Cisco Teknik Tartisma Listesi (Cisco-ttl)
Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk
kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya da
bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu tutulamazlar.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/cisco-ttl/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/cisco-ttl/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:cisco-ttl-digest@yahoogroups.com
mailto:cisco-ttl-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
cisco-ttl-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Received on Mon Oct 16 18:40:19 2006