|
[cisco-ttl] ADSL sorunu
From: actil2003 (actil2003_at_yahoo.com)
Date: Wed Mar 30 2005 - 11:09:19 EEST
Merhaba,
bir adsl kurulumu yapmaya çalışıyorum ancak farkına varmadığım bir
noktada hata yapıyor olabilirim yardımcı olursanız sevinirim.
Daha bir arkadaş buna benzer bir sorun yaşamış burada da IOS hardware
sorunumu var acaba ?
Memhmet
Mevcut konfig şu şkeilde;
--------------------------------------------------------------------
Router# sh int
ATM0 is up, line protocol is up
Hardware is DSLSAR (with Alcatel ADSL Module)
MTU 4470 bytes, sub MTU 4470, BW 64 Kbit, DLY 8000 usec,
reliability 10/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Encapsulation(s): AAL5 AAL2, PVC mode
23 maximum active VCs, 256 VCs per VP, 1 current VCCs
VC Auto Creation Disabled.
VC idle disconnect time: 300 seconds
Last input never, output 00:00:11, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops:
0
Queueing strategy: Per VC Queueing
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
11 packets input, 233 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
13 packets output, 325 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Dialer0 is up, line protocol is up (spoofing)
Hardware is Unknown
Internet address is xx.xx.xx.xx/32
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 1 seconds on reset
Interface is bound to Vi2
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:01:57
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops:
0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 42 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
7 packets input, 264 bytes
8 packets output, 280 bytes
Bound to:
Virtual-Access2 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 56 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Open
Listen: CDPCP
Open: IPCP
PPPoATM vaccess, cloned from Dialer0
Vaccess status 0x44
Bound to ATM0 VCD: 1, VPI: 8, VCI: 35, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
Interface is bound to Di0 (Encapsulation PPP)
Last input 00:00:11, output never, output hang never
Last clearing of "show interface" counters 00:00:32
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops:
0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
14 packets input, 383 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
16 packets output, 399 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
FastEthernet0 is up, line protocol is up
Hardware is PQUICC_FEC, address is 000e.832a.f521 (bia
000e.832a.f521)
Internet address is 192.168.1.1/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 241/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:20, output 00:00:02, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops:
0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
16 packets input, 2409 bytes
Received 11 broadcasts, 0 runts, 0 giants, 0 throttles
19 input errors, 19 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
21 packets output, 2078 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Closed
Base PPPoATM vaccess
Vaccess status 0x40, loopback not set
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:02:06
Input queue: 0/4096/0/0 (size/max/drops/flushes); Total output
drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Virtual-Access2 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 56 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Open
Listen: CDPCP
Open: IPCP
PPPoATM vaccess, cloned from Dialer0
Vaccess status 0x44
Bound to ATM0 VCD: 1, VPI: 8, VCI: 35, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
Interface is bound to Di0 (Encapsulation PPP)
Last input 00:00:17, output never, output hang never
Last clearing of "show interface" counters 00:00:38
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops:
0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
15 packets input, 397 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
17 packets output, 413 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
---------------------------------------------------------------------
Router#sh ver
Cisco IOS Software, C1700 Software (C1700-SY7-M), Version 12.3(8)T5,
RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by Cisco Systems, Inc.
Compiled Wed 20-Oct-04 10:54 by cmong
ROM: System Bootstrap, Version 12.2(7r)XM2, RELEASE SOFTWARE (fc1)
Router uptime is 2 minutes
System returned to ROM by reload
System image file is "flash:c1700-sy7-mz.123-8.T5.bin"
Cisco 1721 (MPC860P) processor (revision 0x300) with 114688K/16384K
bytes of memory.
Processor board ID FOC074706ZQ (3124727761), with hardware revision
0000
MPC860P processor: part number 0, mask 32
1 FastEthernet interface
1 ATM interface
32K bytes of NVRAM.
32768K bytes of processor board System flash (Read/Write)
Configuration register is 0x101
--------------------------------------------------------------------
Router#sh run
Building configuration...
Current configuration : 1173 bytes
!
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
no aaa new-model
ip subnet-zero
!
!
ip dhcp excluded-address 192.168.1.1
!
ip dhcp pool test
network 192.168.1.0 255.255.255.0
default-router 192.18.1.1
!
!
ip cef
!
!
!
!
interface ATM0
no ip address
no ip mroute-cache
no atm ilmi-keepalive
dsl operating-mode auto
pvc 8/35
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
!
interface FastEthernet0
ip address 192.168.1.1 255.255.255.0
no ip mroute-cache
speed auto
!
interface Dialer0
ip address negotiated
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
dialer-group 2
ppp pap sent-username xxxxxxx_at_ttnet password 0 xxxxxx
!
ip classless
ip route 0.0.0.0 0.0.0.0 Dialer0
no ip http server
ip nat inside source list 1 interface Dialer0 overload
!
!
!
access-list 1 permit 192.0.0.0 0.255.255.255
dialer-list 2 protocol ip permit
!
!
--
Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.
Listede onerilen cozumlerin uygulanmasindaki tum sorumluluk kullaniciya aittir. Liste yoneticileri, liste uyeleri ya da bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu tutulamazlar.
Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/cisco-ttl/
<*> To unsubscribe from this group, send an email to:
cisco-ttl-unsubscribe_at_yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
This archive was generated by hypermail 2.1.3
: Wed Mar 30 2005 - 11:10:24 EEST
|