RE: [cisco-ttl] Cisco-1760-v : IOS: c1700-ipvoice-mz.123-4.T4.bin ; CONTROLLER UPDOWN

From: sumero (sumero_at_softhome.net)
Date: Tue Nov 23 2004 - 12:19:36 GMT

  • Next message: ege iyioglu: "[cisco-ttl] cisco 1721 & load sharing"

    clear contr e1 0/0
    yaptiktan sonra halen violation aliyorsan
    fiziksel problem uzerinde durmak gerekir

    farkli bi sdh port'u
    yeni bir kablo cekilmesi gibi...

    -----Original Message-----
    From: AD [mailto:aytunc_at_bilgisistemleri.com.tr]
    Sent: Tuesday, November 23, 2004 11:32 AM
    To: cisco-ttl_at_yahoogroups.com
    Subject: [cisco-ttl] Cisco-1760-v : IOS: c1700-ipvoice-mz.123-4.T4.bin ;
    CONTROLLER UPDOWN

    Herkese merhaba ;

    Bir ucta SDH arkasinda 1760-v uzerinde vwic-2mft-g703 ile diger uctaki SDH
    arkasinda 2691 ve uzerinde vwic-1mft-g703 ile 2 mbps'lik LL baglanti yapmaya
    calisiyorum.

    2691 tarafinda bir problem olmadigini biliyorum , fakat 1760 tarafinda şu
    hata mesajini aliyorum..

    %CONTROLLER-5-UPDOWN: Controller E1 0/0, changed state to down (10 SES)
    %LINK-5-CHANGED: Interface Serial0/0:0, changed state to reset
    %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0:0, changed
    state to down
    %CONTROLLER-5-UPDOWN: Controller E1 0/0, changed state to up
    %LINK-3-UPDOWN: Interface Serial0/0:0, changed state to up
    %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0:0, changed
    state to up

    sh controller , sh run ciktilari aşagida.

    clock ile ilgili bir problem oldugunu zannediyorum , framing ile ugrastim
    ama bir sonuca varamadim. belirli bir sure sonra serial interface line
    protocol down oluyor.

    sh controllers'ta linecode violation degerleri yuksek..

    Yardimci olabilirseniz cok sevinirim.

    Router#sh controllers e1 0/0

    E1 0/0 is up.

      Applique type is Channelized E1 - balanced

      No alarms detected.

      alarm-trigger is not set

      Version info Firmware: 20030807, FPGA: 11

      Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.

      Data in current interval (477 seconds elapsed):

         1420 Line Code Violations, 4960 Path Code Violations

         463 Slip Secs, 0 Fr Loss Secs, 40 Line Err Secs, 0 Degraded Mins

         455 Errored Secs, 0 Bursty Err Secs, 8 Severely Err Secs, 4 Unavail
    Secs

      Data in Interval 1:

         289555 Line Code Violations, 18099 Path Code Violations

         256 Slip Secs, 6 Fr Loss Secs, 178 Line Err Secs, 2 Degraded Mins

         261 Errored Secs, 0 Bursty Err Secs, 64 Severely Err Secs, 8 Unavail
    Secs

      Data in Interval 2:

         184401 Line Code Violations, 13028 Path Code Violations

         55 Slip Secs, 0 Fr Loss Secs, 370 Line Err Secs, 6 Degraded Mins

         334 Errored Secs, 0 Bursty Err Secs, 58 Severely Err Secs, 233 Unavail
    Secs

      Total Data (last 2 15 minute intervals):

         473956 Line Code Violations, 31127 Path Code Violations,

         311 Slip Secs, 6 Fr Loss Secs, 548 Line Err Secs, 8 Degraded Mins,

         595 Errored Secs, 0 Bursty Err Secs, 122 Severely Err Secs, 241 Unavail
    Secs

    Router#sh run

    Building configuration...

    Current configuration : 923 bytes

    !

    version 12.3

    service timestamps debug datetime msec

    service timestamps log datetime msec

    service password-encryption

    !

    hostname Router

    !

    boot-start-marker

    boot-end-marker

    !

    tdm clock E1 0/0 data export line

    voice-card 0

    !

    voice-card 1

    !

    no aaa new-model

    ip subnet-zero

    ip cef

    !

    controller E1 0/0

     framing NO-CRC4

     channel-group 0 timeslots 1-31 speed 64

    !

    controller E1 0/1

     framing NO-CRC4

    !

    controller E1 1/0

     framing NO-CRC4

    !

    !

    !

    interface FastEthernet0/0

     ip address x.x.x.x 255.255.255.224

     speed auto

    !

    interface Serial0/0:0

     ip address x.x.x.x 255.255.255.252

     encapsulation ppp

    !

    ip classless

    ip route 0.0.0.0 0.0.0.0 FastEthernet0/0

    no ip http server

    [Non-text portions of this message have been removed]

    Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.

    Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir
    e-posta gönderebilirsiniz.
    Yahoo! Groups Links

    ------------------------ Yahoo! Groups Sponsor --------------------~-->
    Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
    Now with Pop-Up Blocker. Get it for free!
    http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/26EolB/TM
    --------------------------------------------------------------------~->

    Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.

    Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
    Yahoo! Groups Links

    <*> To visit your group on the web, go to:
        http://groups.yahoo.com/group/cisco-ttl/

    <*> To unsubscribe from this group, send an email to:
        cisco-ttl-unsubscribe_at_yahoogroups.com

    <*> Your use of Yahoo! Groups is subject to:
        http://docs.yahoo.com/info/terms/
     

    This archive was generated by hypermail 2.1.5 : Tue Nov 23 2004 - 16:17:51 GMT