Next message: Sinan Oztimur: "RE: [cisco-ttl] Cisco 2509 ve Ascend Max 6000 : Bagalanti Turu"
Eger iki router da Cisco degilse Cisco HDLC encapsulation'i
kullanamazsiniz.
Eger dogru hatirliyorsam, Ascend'lerin de HDLC destegi olacakti. Ama
Cisco ve Ascend uzerindeki HDLC encapsulation'lari -isimleri ayni
olmasina ragmen- birbiriyle uyumlu degil.
PPP kullanmaniz gerekli.
Ilker
Mehmet Ali Suzen wrote:
> Config icin tesekur ederim. Fakat karsi taraftaki router malasef
> Cisco degil (AScend Max 6000). HDLC destegi secenegini bulamadim,
> encapsulationda. Bir fikriniz var mi.
>
> -Mehmet
>
>
>>HDLC Cisco'nun serial interface 'deki default protocoludur. Eger Encap XXX
>>kullanmaz isen HDLC secilir..
>>ornek;
>>Router A
>>interface Serial0
>>ip address 10.200.1.1 255.255.255.252
>>ip access-group 101 in
>>ip access-group 100 out
>>no ip proxy-arp
>>ip accounting output-packets
>>no ip route-cache
>>no ip mroute-cache
>>
>>rtdc09#sh int ser0
>>Serial0 is up, line protocol is up
>> Hardware is PowerQUICC Serial
>> Internet address is 10.200.1.1/30
>> MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
>> reliability 255/255, txload 1/255, rxload 1/255
>> Encapsulation HDLC, loopback not set
>> Keepalive set (10 sec)
>> Last input 00:00:02, output 00:00:02, output hang never
>> Last clearing of "show interface" counters 31w1d
>> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
>> Queueing strategy: weighted fair
>> Output queue: 0/1000/64/0 (size/max total/threshold/drops)
>> Conversations 0/67/256 (active/max active/max total)
>> Reserved Conversations 0/0 (allocated/max allocated)
>> Available Bandwidth 1158 kilobits/sec
>> 5 minute input rate 0 bits/sec, 1 packets/sec
>> 5 minute output rate 1000 bits/sec, 1 packets/sec
>>
>>Router B ;
>>interface Serial0
>>ip address 10.200.1.2 255.255.255.252
>>ip access-group 100 in
>>ip access-group 101 out
>>no ip proxy-arp
>>no ip route-cache
>>no ip mroute-cache
>>
>>RTCH01#sh int ser0
>>Serial0 is up, line protocol is up
>> Hardware is PowerQUICC Serial
>> Internet address is 10.200.1.2/30
>> MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
>> reliability 255/255, txload 1/255, rxload 1/255
>> Encapsulation HDLC, loopback not set
>> Keepalive set (10 sec)
>> Last input 00:00:00, output 00:00:00, output hang never
>> Last clearing of "show interface" counters never
>> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
>> Queueing strategy: weighted fair
>> Output queue: 0/1000/64/0 (size/max total/threshold/drops)
>> Conversations 0/2/256 (active/max active/max total)
>> Reserved Conversations 0/0 (allocated/max allocated)
>> Available Bandwidth 1158 kilobits/sec
>> 5 minute input rate 0 bits/sec, 1 packets/sec
>> 5 minute output rate 0 bits/sec, 1 packets/sec
>>
>>
>>
>>Please respond to cisco-ttl_at_yahoogroups.com
>>
>>To: cisco-ttl_at_yahoogroups.com
>>cc:
>>Subject: Re: [cisco-ttl] Cisco 2509 ve Ascend Max 6000 : Bagalanti
>>Turu
>>
>>
>>Bu kendi ozel WAN baglantimiz, yani carrier isinide
>>biz yapiyoruz, HDLC Cisco'nun property PPP protokoluymus?
>>Bahsettginiz ornegi gonderebilirseniz, cok sevinirim.
>>iyi calismalar,
>>-Mehmet
>>
>>
>>>Hangi carrier'in DSL servisi bu ? Onlarla konustunuzmu ??
>>>Genellikle, eger point-to-point link varsa HDLC en kolay link
>>>protokoludur. Butun routerlarda kullanilabilir.
>>>Istersen bir ornek yollayabirim.
>>>Serhat
>>>
>>>
>>>Please respond to cisco-ttl_at_yahoogroups.com
>>>
>>>To: cisco-ttl_at_yahoogroups.com
>>>cc:
>>>Subject: [cisco-ttl] Cisco 2509 ve Ascend Max 6000 : Bagalanti
>>
>>Turu
>>
>>>
>>>iyi gunler Arkadaslar,
>>>Cisco 2511 routerimizi baska bir sehirdeki, access noktamizdaki
>>>(POP) Ascend Max 6000 ile konusturmak istiyoruz, bunun icin
>>>Cisco 2511'in Serial portundan DTE kablo ile DSL modeme ve
>>>ordanda diger 3. parti routerin (Max 600) E1 portuna gidiyor
>>>
>>>Cisco2509--serial 0
>>><----over DTE Cable--V35>
>>>Alcatel HDSL
>>><----telco over line L1 L2 ---->
>>>Alcatel HDSL
>>><---G703---RJ48--->
>>>E1 port Ascend Max 6000
>>>
>>>Her iki encapsulation tipinide denedik PPP ve Frame-Relay, fakat
>>>bir turlu 2 router bir birini gormuyor. Her iki durumdada
>>>#sh int ser 0
>>>ciktisinda "line protocol is down" seklinde aliyoruz,
>>>cikti tam olarak asagida veriyorum.
>>>
>>>Ayrica PPP yi debug ettik;
>>>#ter mon
>>>#debug ppp negotiation
>>>01:48:52: Se0 LCP: TIMEout: State Listen
>>>01:48:52: Se0 LCP: O CONFREQ [Listen] id 11 len 15
>>>01:48:52: Se0 LCP: AuthProto CHAP (0x0305C22305)
>>>01:48:52: Se0 LCP: MagicNumber 0x10DF94FF (0x050610DF94FF)
>>>01:48:54: Se0 LCP: TIMEout: State REQsent
>>>01:48:54: Se0 LCP: O CONFREQ [REQsent] id 12 len 15
>>>01:48:54: Se0 LCP: AuthProto CHAP (0x0305C22305)
>>>01:48:54: Se0 LCP: MagicNumber 0x10DF94FF (0x050610DF94FF)
>>>
>>>Boyle bir baglanti, mumkun mu? Hangi encapsulation'i
>>>kullanmamiz gerekli? Her hangi bir fikri olan var mi?
>>>
>>>iyi calismalar,
>>>-Mehmet
>>>
>>>serial 0:
>>>!
>>>interface Serial0
>>>ip address 192.168.1.60 255.255.255.224
>>>encapsulation ppp
>>>ppp authentication chap
>>>ppp chap password 7 1248574446
>>>!
>>>
>>>Here is the status of interface
>>># sh int ser 0
>>>cyrus-r35#sh interfaces serial 0
>>>Serial0 is up, line protocol is down
>>>Hardware is HD64570
>>>MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
>>>reliability 255/255, txload 1/255, rxload 1/255
>>>Encapsulation PPP, loopback not set
>>>Keepalive set (10 sec)
>>>LCP Listen
>>>Closed: CDPCP
>>>Last input never, output 00:00:08, output hang never
>>>Last clearing of "show interface" counters 00:09:36
>>>Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
>>>Queueing strategy: weighted fair
>>>Output queue: 0/1000/64/0 (size/max total/threshold/drops)
>>>Conversations 0/1/256 (active/max active/max total)
>>>Reserved Conversations 0/0 (allocated/max allocated)
>>>5 minute input rate 0 bits/sec, 0 packets/sec
>>>5 minute output rate 0 bits/sec, 0 packets/sec
>>>0 packets input, 0 bytes, 0 no buffer
>>>Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
>>>0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
>>>119 packets output, 2261 bytes, 0 underruns
>>>0 output errors, 0 collisions, 31 interface resets
>>>0 output buffer failures, 0 output buffers swapped out
>>>0 carrier transitions
>>>DCD=up DSR=up DTR=up RTS=up CTS=up
>>>
>>>
>>>
>>
>>
>>
>>Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.
>>
>>Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir
>>e-posta gönderebilirsiniz.
>>Yahoo! Groups Links
>>
>>
>>
>>
>>
>>
>>
>>
>
>
>
>
>
> Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.
>
> Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
> Yahoo! Groups Links
>
>
>
>
------------------------ Yahoo! Groups Sponsor --------------------~-->
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/26EolB/TM
--------------------------------------------------------------------~->
Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.
Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/cisco-ttl/
<*> To unsubscribe from this group, send an email to:
cisco-ttl-unsubscribe_at_yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
This archive was generated by hypermail 2.1.5
: Wed Jun 23 2004 - 10:45:01 GMT