Next message: erkan erdem: "Re: [cisco-ttl] static route sorunu"
Config icin tesekur ederim. Fakat karsi taraftaki router malasef
Cisco degil (AScend Max 6000). HDLC destegi secenegini bulamadim,
encapsulationda. Bir fikriniz var mi.
-Mehmet
> HDLC Cisco'nun serial interface 'deki default protocoludur. Eger Encap XXX
> kullanmaz isen HDLC secilir..
> ornek;
> Router A
> interface Serial0
> ip address 10.200.1.1 255.255.255.252
> ip access-group 101 in
> ip access-group 100 out
> no ip proxy-arp
> ip accounting output-packets
> no ip route-cache
> no ip mroute-cache
>
> rtdc09#sh int ser0
> Serial0 is up, line protocol is up
> Hardware is PowerQUICC Serial
> Internet address is 10.200.1.1/30
> MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
> reliability 255/255, txload 1/255, rxload 1/255
> Encapsulation HDLC, loopback not set
> Keepalive set (10 sec)
> Last input 00:00:02, output 00:00:02, output hang never
> Last clearing of "show interface" counters 31w1d
> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
> Queueing strategy: weighted fair
> Output queue: 0/1000/64/0 (size/max total/threshold/drops)
> Conversations 0/67/256 (active/max active/max total)
> Reserved Conversations 0/0 (allocated/max allocated)
> Available Bandwidth 1158 kilobits/sec
> 5 minute input rate 0 bits/sec, 1 packets/sec
> 5 minute output rate 1000 bits/sec, 1 packets/sec
>
> Router B ;
> interface Serial0
> ip address 10.200.1.2 255.255.255.252
> ip access-group 100 in
> ip access-group 101 out
> no ip proxy-arp
> no ip route-cache
> no ip mroute-cache
>
> RTCH01#sh int ser0
> Serial0 is up, line protocol is up
> Hardware is PowerQUICC Serial
> Internet address is 10.200.1.2/30
> MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
> reliability 255/255, txload 1/255, rxload 1/255
> Encapsulation HDLC, loopback not set
> Keepalive set (10 sec)
> Last input 00:00:00, output 00:00:00, output hang never
> Last clearing of "show interface" counters never
> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
> Queueing strategy: weighted fair
> Output queue: 0/1000/64/0 (size/max total/threshold/drops)
> Conversations 0/2/256 (active/max active/max total)
> Reserved Conversations 0/0 (allocated/max allocated)
> Available Bandwidth 1158 kilobits/sec
> 5 minute input rate 0 bits/sec, 1 packets/sec
> 5 minute output rate 0 bits/sec, 1 packets/sec
>
>
>
> Please respond to cisco-ttl_at_yahoogroups.com
>
> To: cisco-ttl_at_yahoogroups.com
> cc:
> Subject: Re: [cisco-ttl] Cisco 2509 ve Ascend Max 6000 : Bagalanti
> Turu
>
>
> Bu kendi ozel WAN baglantimiz, yani carrier isinide
> biz yapiyoruz, HDLC Cisco'nun property PPP protokoluymus?
> Bahsettginiz ornegi gonderebilirseniz, cok sevinirim.
> iyi calismalar,
> -Mehmet
>
>> Hangi carrier'in DSL servisi bu ? Onlarla konustunuzmu ??
>> Genellikle, eger point-to-point link varsa HDLC en kolay link
>> protokoludur. Butun routerlarda kullanilabilir.
>> Istersen bir ornek yollayabirim.
>> Serhat
>>
>>
>> Please respond to cisco-ttl_at_yahoogroups.com
>>
>> To: cisco-ttl_at_yahoogroups.com
>> cc:
>> Subject: [cisco-ttl] Cisco 2509 ve Ascend Max 6000 : Bagalanti
> Turu
>>
>>
>> iyi gunler Arkadaslar,
>> Cisco 2511 routerimizi baska bir sehirdeki, access noktamizdaki
>> (POP) Ascend Max 6000 ile konusturmak istiyoruz, bunun icin
>> Cisco 2511'in Serial portundan DTE kablo ile DSL modeme ve
>> ordanda diger 3. parti routerin (Max 600) E1 portuna gidiyor
>>
>> Cisco2509--serial 0
>> <----over DTE Cable--V35>
>> Alcatel HDSL
>> <----telco over line L1 L2 ---->
>> Alcatel HDSL
>> <---G703---RJ48--->
>> E1 port Ascend Max 6000
>>
>> Her iki encapsulation tipinide denedik PPP ve Frame-Relay, fakat
>> bir turlu 2 router bir birini gormuyor. Her iki durumdada
>> #sh int ser 0
>> ciktisinda "line protocol is down" seklinde aliyoruz,
>> cikti tam olarak asagida veriyorum.
>>
>> Ayrica PPP yi debug ettik;
>> #ter mon
>> #debug ppp negotiation
>> 01:48:52: Se0 LCP: TIMEout: State Listen
>> 01:48:52: Se0 LCP: O CONFREQ [Listen] id 11 len 15
>> 01:48:52: Se0 LCP: AuthProto CHAP (0x0305C22305)
>> 01:48:52: Se0 LCP: MagicNumber 0x10DF94FF (0x050610DF94FF)
>> 01:48:54: Se0 LCP: TIMEout: State REQsent
>> 01:48:54: Se0 LCP: O CONFREQ [REQsent] id 12 len 15
>> 01:48:54: Se0 LCP: AuthProto CHAP (0x0305C22305)
>> 01:48:54: Se0 LCP: MagicNumber 0x10DF94FF (0x050610DF94FF)
>>
>> Boyle bir baglanti, mumkun mu? Hangi encapsulation'i
>> kullanmamiz gerekli? Her hangi bir fikri olan var mi?
>>
>> iyi calismalar,
>> -Mehmet
>>
>> serial 0:
>> !
>> interface Serial0
>> ip address 192.168.1.60 255.255.255.224
>> encapsulation ppp
>> ppp authentication chap
>> ppp chap password 7 1248574446
>> !
>>
>> Here is the status of interface
>> # sh int ser 0
>> cyrus-r35#sh interfaces serial 0
>> Serial0 is up, line protocol is down
>> Hardware is HD64570
>> MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
>> reliability 255/255, txload 1/255, rxload 1/255
>> Encapsulation PPP, loopback not set
>> Keepalive set (10 sec)
>> LCP Listen
>> Closed: CDPCP
>> Last input never, output 00:00:08, output hang never
>> Last clearing of "show interface" counters 00:09:36
>> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
>> Queueing strategy: weighted fair
>> Output queue: 0/1000/64/0 (size/max total/threshold/drops)
>> Conversations 0/1/256 (active/max active/max total)
>> Reserved Conversations 0/0 (allocated/max allocated)
>> 5 minute input rate 0 bits/sec, 0 packets/sec
>> 5 minute output rate 0 bits/sec, 0 packets/sec
>> 0 packets input, 0 bytes, 0 no buffer
>> Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
>> 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
>> 119 packets output, 2261 bytes, 0 underruns
>> 0 output errors, 0 collisions, 31 interface resets
>> 0 output buffer failures, 0 output buffers swapped out
>> 0 carrier transitions
>> DCD=up DSR=up DTR=up RTS=up CTS=up
>>
>>
>>
>
>
>
> Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.
>
> Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir
> e-posta gönderebilirsiniz.
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
------------------------ Yahoo! Groups Sponsor --------------------~-->
Yahoo! Domains - Claim yours for only $14.70
http://us.click.yahoo.com/Z1wmxD/DREIAA/yQLSAA/26EolB/TM
--------------------------------------------------------------------~->
Bu listenin Cisco Systems ile herhangi bir baglantisi bulunmamaktadir.
Listeden cikmak için cisco-ttl-unsubscribe_at_yahoogroups.com adresine bir e-posta gönderebilirsiniz.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/cisco-ttl/
<*> To unsubscribe from this group, send an email to:
cisco-ttl-unsubscribe_at_yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
This archive was generated by hypermail 2.1.5
: Wed Jun 23 2004 - 10:02:36 GMT