[cisco-ttl] RIP

From: Yasin BATMAZ (yasin_at_exper.net.tr)
Date: Sat Jan 03 2004 - 16:51:23 GMT

Next message: TANER BAŞULAŞ: "Ynt: [cisco-ttl] RIP"

Previous message: EMRAHBIL: "[cisco-ttl] mutlu yillar"
Next in thread: emre aksoy: "[cisco-ttl] ccie r&s"
Reply: emre aksoy: "[cisco-ttl] ccie r&s"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Arkadaşlar merhaba,

RIP was originally specified in RFC 1058. Its key characteristics
include the following:
* It is a distance-vector routing protocol.
* Hop count is used as the metric for path selection.
* The maximum allowable hop count is 15.
* By default, routing updates are broadcast every 30 seconds.

CCNA notlarından yukarıdaki bilgiye ulaştım.

Daha sonra aşağıdaki çıktıyı router'dan aldım. Buradaki 120 olan
"Distance" ile yukarıdaki max 15 olan "hop count" arasındaki fark
nedir?

Teşşekürler.

Yasin BATMAZ

*********#show ip protocols
Routing Protocol is "rip"
  Sending updates every 30 seconds, next due in 29 seconds
  Invalid after 180 seconds, hold down 180, flushed after 240
  Outgoing update filter list for all interfaces is not set
  Incoming update filter list for all interfaces is not set
  Redistributing: rip
  Default version control: send version 2, receive version 2
    Interface Send Recv Triggered RIP Key-chain
    FastEthernet0 2 2
    Serial1 2 2
  Automatic network summarization is in effect
  Maximum path: 4
  Routing for Networks:
    192.168.2.0
  Routing Information Sources:
    Gateway Distance Last Update
    192.168.2.1 120 19:43:03
    192.168.2.240 120 00:05:00
  Distance: (default is 120)

Next message: TANER BAŞULAŞ: "Ynt: [cisco-ttl] RIP"
Previous message: EMRAHBIL: "[cisco-ttl] mutlu yillar"
Next in thread: emre aksoy: "[cisco-ttl] ccie r&s"
Reply: emre aksoy: "[cisco-ttl] ccie r&s"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.5 : Sat Jan 03 2004 - 10:52:17 GMT