Next message: Devrim Yener Kucuk: "Re: [cisco-ttl] output buffers swapped out"
Devrim selam,
rou1#sh int fastEthernet 11/1/1
FastEthernet11/1/1 is up, line protocol is up
Hardware is cyBus FastEthernet Interface, address is 00e0.f752.b269 (bia
00e0.f752.b269)
Description:
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 16/255, rxload 22/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:34:07
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 6142
Queueing strategy: weighted fair
Output queue: 0/1000/512/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 75000 kilobits/sec
30 second input rate 8640000 bits/sec, 2284 packets/sec
30 second output rate 6521000 bits/sec, 1996 packets/sec
4862752 packets input, 2234779361 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
4331670 packets output, 1652396178 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 109114 output buffers swapped out
rou1#show version
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.2(10.1)T, MAINTENANCE INTERIM
SOFTWARE
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sun 07-Apr-02 00:14 by ccai
Image text-base: 0x60010948, data-base: 0x61BD0000
ROM: System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1)
BOOTLDR: RSP Software (RSP-BOOT-M), Version 12.0(8)S, EARLY DEPLOYMENT
RELEASE SOFTWARE (fc1)
rou1 uptime is 1 week, 4 days, 15 hours, 45 minutes
System returned to ROM by error - a Software forced crash, PC 0x6038A9D4
System restarted at 00:56:10 TURKEY Sun Dec 29 2002
System image file is "slot0:rsp-jsv-mz.122-10.1.T"
cisco RSP8 (R7000) processor with 262144K/8216K bytes of memory.
R7000 CPU at 250Mhz, Implementation 39, Rev 2.1, 256KB L2, 2048KB L3 Cache
Last reset from power-on
G.703/E1 software, Version 1.0.
G.703/JT2 software, Version 1.0.
Channelized E1, Version 1.0.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Bridging software.
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
Chassis Interface.
1 EIP controller (6 Ethernet).
3 FSIP controllers (24 Serial).
1 VIP2 controller (8 E1).
2 VIP2 R5K controllers (2 FastEthernet)(8 E1)(1 ATM).
6 Ethernet/IEEE 802.3 interface(s)
2 FastEthernet/IEEE 802.3 interface(s)
70 Serial network interface(s)
1 ATM network interface(s)
2043K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
16384K bytes of Flash internal SIMM (Sector size 256K).
Slave in slot 7 is running Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-DW-M), Version 12.2(10.1)T, MAINTENANCE INTERIM
SOFTWARE
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 05-Apr-02 22:15 by ccai
Slave: Loaded from system
Slave: cisco RSP8 (R7000) processor with 262144K bytes of memory.
Configuration register is 0x10F
Akgun.
-----Original Message-----
From: dkucuk@cisco.com [mailto:dkucuk@cisco.com]
Sent: 09 Ocak 2003 Perşembe 16:28
To: cisco-ttl@yahoogroups.com
Subject: Re: [cisco-ttl] output buffers swapped out
Akgul selam
en azindan sh ver ve sh int fast outputu da yollayabilir misin?
ve yogun traffic , ya da ftp hangi tip traffic de artiyor gibi bir
gozlemin oldu mu?
sevgiler
akgun ozsoy wrote:
> output buffers swapped out
> surekli artan bu parametre icin ne yapabilirim?
> encapsulation ISL.
> cisco 7500 fast ethernet.
>
> tesekkurler.
>
> akgun.
>
> Bu listden çıkmak için cisco-ttl-unsubscribe@yahoogroups.com adresine
bir
> e-posta göndermeniz yeterlidir.
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
>
> Bu listden çıkmak için cisco-ttl-unsubscribe@yahoogroups.com adresine
bir
> e-posta göndermeniz yeterlidir.
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
>
>
> Bu listden çıkmak için cisco-ttl-unsubscribe@yahoogroups.com adresine
bir e-posta göndermeniz yeterlidir.
>
>
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
Bu listden çıkmak için cisco-ttl-unsubscribe@yahoogroups.com adresine bir
e-posta göndermeniz yeterlidir.
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
This archive was generated by hypermail 2.1.5
: Thu Jan 09 2003 - 16:52:37 GMT